* * *
*   
 
 
*
 
*
Home :: Forum :: Help :: Search :: Login :: Register
* *
*

+ pro-tourings10.com  » Chassis & Suspension  » General Suspension 
|- Can someone measure a stock spindle for me? 
Welcome, Guest. Please login or register.

Login with username, password and session length

*
* * *
* *
*



« previous next »
Pages: [1]   Go Down

Author Topic: Can someone measure a stock spindle for me?  (Read 1462 times)

Offline DRC
  • Newbie
  • *
  • Posts: 6
  • Rep: +0/-0
Can someone measure a stock spindle for me?
« on: December 30, 2009, 06:03:21 PM »
im looking for the distance from the axle stub center line, to the bottom ball joint in a vertical plane. a good round figure is fine.

thanks!
Logged

Re: Can someone measure a stock spindle for me?

Offline 87wildside
  • Hero Member
  • *****
  • Posts: 935
  • Rep: +0/-0
  • ...it's easy if you want to do it
Re: Can someone measure a stock spindle for me?
« Reply #1 on: December 31, 2009, 05:58:35 PM »
I'll try to get it after work tomorrow. If I forget just bump the thread.
Logged

Re: Can someone measure a stock spindle for me?

Offline DRC
  • Newbie
  • *
  • Posts: 6
  • Rep: +0/-0
Re: Can someone measure a stock spindle for me?
« Reply #2 on: January 01, 2010, 06:13:00 PM »
any luck?
Logged

Re: Can someone measure a stock spindle for me?

Offline 87wildside
  • Hero Member
  • *****
  • Posts: 935
  • Rep: +0/-0
  • ...it's easy if you want to do it
Re: Can someone measure a stock spindle for me?
« Reply #3 on: January 02, 2010, 04:52:42 AM »
I forgot. I'll try to remember today.
Logged

Re: Can someone measure a stock spindle for me?

Offline 87wildside
  • Hero Member
  • *****
  • Posts: 935
  • Rep: +0/-0
  • ...it's easy if you want to do it
Re: Can someone measure a stock spindle for me?
« Reply #4 on: January 02, 2010, 03:45:08 PM »
Came up with roughly 2". That was from the bottom of the knuckle to the the spindle center line.
Logged

Re: Can someone measure a stock spindle for me?

Offline DRC
  • Newbie
  • *
  • Posts: 6
  • Rep: +0/-0
Re: Can someone measure a stock spindle for me?
« Reply #5 on: January 02, 2010, 05:59:14 PM »
awesome, that will do. thanks!
Logged
Pages: [1]   Go Up
« previous next »
 
*
* * *
*
*